Toyota Avalon (XX50): 2gr-fks Spark Plug

Components

COMPONENTS

ILLUSTRATION

*1	IGNITION COIL ASSEMBLY	*2	SPARK PLUG
*3	V-BANK COVER SUB-ASSEMBLY	*4	VACUUM HOSE
	N*m (kgf*cm, ft.*lbf): Specified torque	-	-

Installation

INSTALLATION

PROCEDURE

1. INSTALL SPARK PLUG

HINT:

Perform "Inspection After Repair" after replacing a spark plug.

Click here

(a) Install the 6 spark plugs to the cylinder head sub-assembly and cylinder head LH.

Torque:

18 N·m {184 kgf·cm, 13 ft·lbf}

NOTICE:

If a spark plug has been struck or dropped, replace it.

HINT:

Install the same parts to their original positions.

2. INSTALL IGNITION COIL ASSEMBLY

Click here

3. INSTALL V-BANK COVER SUB-ASSEMBLY

Click here

4. PERFORM INITIALIZATION

(a) Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.

Click here

Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Replacement of ignition coil assembly Replacement of spark plug	Inspection after repair	Poor idle, etc. Engine start function, etc.

PROCEDURE

1. REMOVE V-BANK COVER SUB-ASSEMBLY

Click here

2. REMOVE IGNITION COIL ASSEMBLY

Click here

3. REMOVE SPARK PLUG

(a) Remove the 6 spark plugs from the cylinder head sub-assembly and cylinder head LH. NOTICE: If a spark plug has been struck or dropped, replace it. HINT: Arrange the removed parts in the correct order.