Replacement
REPLACEMENT
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here 
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER
Click here
4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Click here
5. REPLACE HYBRID TRANSAXLE FLUID
(a) Lift the vehicle. [#1]
NOTICE:
Set
the vehicle on a lift so that the vehicle is kept level when it is
lifted up (make sure that the tilt angle from the front to rear of the
vehicle is within +/- 1°).
|
(b) Using a 10 mm hexagon socket wrench, remove the filler plug and gasket from the hybrid vehicle transaxle assembly. [#2] |
|
| (c)
Using a 10 mm hexagon socket wrench, remove the drain plug and gasket
from the hybrid vehicle transaxle assembly and drain the hybrid
transaxle fluid. [#3] | |
(d)
Using a 10 mm hexagon socket wrench, temporarily install the drain plug
and gasket to the hybrid vehicle transaxle assembly. [#4]
HINT:
Reuse the old gasket as the drain plug will be removed again.
| (e)
Add hybrid transaxle fluid until the hybrid transaxle fluid level is
between 0 to 10 mm (0 to 0.394 in.) from the bottom lip of the filler
plug opening. [#5]
NOTICE:
- Use Toyota Genuine ATF WS.
- Be sure to fully insert the filler nozzle into the filler plug opening.
- Be sure to add hybrid transaxle fluid slowly. If hybrid transaxle fluid
is added quickly, the hybrid transaxle fluid may hit internal parts and
bounce back, resulting in hybrid transaxle fluid coming out of the
filler plug opening.
- Be sure to directly check that the hybrid transaxle fluid level is within the specified range.
- An insufficient or excessive amount of hybrid transaxle fluid may damage the hybrid vehicle transaxle assembly.
|
 |
|
*a | Filler Nozzle | |
*b | 0 to 10 mm (0 to 0.394 in.) | | |
(f)
Using a 10 mm hexagon socket wrench, temporarily install the filler
plug and gasket to the hybrid vehicle transaxle assembly. [#6]
HINT:
Reuse the old gasket as the filler plug will be removed again.
(g) Lower the vehicle. [#7]
(h) Put the engine in Inspection Mode (Maintenance Mode). [#8]
Click here
(i) Idle the engine for 30 seconds with the power switch on (READY). [#9]
(j) Turn the power switch off. [#10]
(k) Repeat steps [#1] to [#10].
(l) Repeat steps [#1] to [#3].
(m) Using a 10 mm hexagon socket wrench, install the drain plug and a new gasket to the hybrid vehicle transaxle assembly.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
(n)
Using a 10 mm hexagon socket wrench, temporarily install the filler
plug and gasket to the hybrid vehicle transaxle assembly.
HINT:
Reuse the old gasket as the filler plug will be removed again.
6. ADD HYBRID TRANSAXLE FLUID
Click here
7. INSPECT HYBRID TRANSAXLE FLUID
Click here
8. INSPECT FOR HYBRID TRANSAXLE FLUID LEAK
9. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Click here
10. INSTALL NO. 1 ENGINE UNDER COVER
Click here
11. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Click here
12. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Click here
